Bit inspection – Castle LB-23 Operator Manual User Manual
Page 20
Advertising
Add 10 to 15 drops of oil to each of the holes. The oil is picked up by the
wick and distributed evenly among the spindles
Locate the Drive Link Pins and add 1 or 2 drops of oil to each. The pins
can be oiled once every 30 hours of usage. However, this should only be
done if the head is in good adjustment, but still has a metallic rattle.
After the oil is added, the machine should be left running for AT LEAST
30 minutes and then all excess oil wiped off. If the clean up of the oil is
not thorough enough, the machine will throw oil on the stock.
Bit Inspection
Look over and inspect all of the bits while carrying out the lubrication
process. Look for chips in the bits and replace if necessary.
18
Advertising