J&M 4WS17 - Manual (Page 24)

23
W
IrInG
h
arneSS
1) Run the short harness, starting with the 4 way flat connectors go through the light bar starting on the side nearest
to the rear axle. Facing the light bar from the front, the wire will need to be run from left to right through the chan-
nel on the outside of the light bar. Connect the 4 way flat connector to the 4 way flat connector coming out of the left
hand light. Now run whats remaining of the short harness to the right side through the inside of the main tube on the
light bar.
2) Connect the 3 way flat connector that is coming off of the short harness to the 3 way flat connection coming out of
the light enhancer.
3) Connect the light enhancer to the long harness with the two 4 way square connectors.
4) Run the 3 male 1 female flat connector to the front of the 4WS top bar. Run the end of the connector through the
top bar. There is a hole for the wire to come out of the bottom of the top bar near the front of the wagon. Now run it
through the front axle, starting at the bottom rear left hand side to the middle front hole. Next go down the tongue, to
the cord wrap. For transportation connect the 4 way flat connector to the vehicle and wrap the remaining cord around
the cord wrap.
L/H
R/H
Start Here
Long Harness
Short Harness