J&M HS-36B - Manual (Page 7)

7
SET-UP INSTRUCTIONS
1. Mounting the Rear Axles
Secure the Dura-Flex Rear Axles (61) to the axle mounts
located on the underside of the Header Transport Main Frame
(1) using four 5/8” x 1-3/4” Grade 5 bolts (48) with eight 5/8”
flat washers (83) and four 5/8” locknuts (84). NOTE: The
axle should be positioned so the spindle is located toward
the rear of the axle centerline.
SAFETY SIGNS
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
Replace Immediately If Damaged or Missing!
IMPORTANT: Install new safety signs if the old signs are destroyed,
lost, painted over or cannot be read. When parts are replaced that
have safety signs, make sure you install a new sign with each new
part. New signs are available from the manufacturer or your
authorized dealer.
2. Mounting the Rear Tires
Secure one tire and wheel assembly (18)(16) to each of the
rear hub assemblies using the wheel nuts (17) provided. Use
a star pattern to tighten the spindle nuts according to SAE
standards.
Position both axles so
the spindle is located
toward the rear of the axle
centerline.
48 83 84
61
6
1
3
5
2
4