Db a – CEMB USA C202 User Manual
Page 12
I 0592 - 12
7
d
b
a
GB
5.3.2 - Manual presetting
5.3.2.1 - Standard wheels
►
►
If necessary, the dimensions can be inserted or edited in manual mode as follows:
- press
+
or else press
from the Dimensions screen in automatic mode (which can
be reached by pulling out the distance + diameter gauge).
- press
to select the dimension to be preset (highlighted in red).
- press
/
to preset the required value.
- press
to change unit of measurement.
- press
to switch to the Manual Presetting screen for the ALU dimensions
- press
to return to the Measurements screen
Defi nition of dimensions:
d = DIAMETER: Preset the nominal diameter stamped on the rim.
b = WIDTH:
Preset the nominal width indicated on the rim.
a = DISTANCE: Preset the distance of the inside of the wheel from the machine measured with special gauge as
described
in
fi g. 7.