CEMB USA K8 (C) - Manual (Page 6)

I 0668 - 6
b
a
d
a
b
c
b
GB
4
►
.1 - PRESETTING OF WHEEL DIMENSIONS
4.1.1 - STANDARD WHEELS
►
a. Preset distance “a” for the inside of the wheel
from the machine.
b. Set the rated width, which is generally indicated
on the rim, or measure width “b” using the com
pass gauge supplied.
c. Preset the nominal diameter “d” indicated on the
tyre.
4.1.2
►
- WHEEL WITH CORRECTION INSIDE RIM
Measure the dimensions according to the diagram shown below using the dedicated gauge. ▪
Sele ▪ ct the weight application position using the buttons ( CONTROL PANEL AND
DISPLAY buttons 9-10)
PRESETTING:
NOTE: dE setting is not required, since it is
automatically deduced from d.
To set dE, hold the button 10 down for 2 seconds when
any one of the dimensions is shown on the display.
4.2
►
- RESULT OF MEASUREMENT
Position the wheel to activate the LEDs on the relative side. A 0 will appear if unbalance is within tole
rance; use to read values under the tolerance threshold provided.
USE OF THE WHEEL BALANCER