CHIEF KWT110 - Manual (Page 8)

KWT-110 Installation Instructions
8
ASSEMBLY AND INSTALLATION - CPU
MOUNT
Installation of Protective Rubber Edging
1. Place four strips of protective rubber edging (E) over the
sharp edges located on the top and bottom of the CPU
mount (D). (See Figure 1)
Figure 1
CPU Installation
2. Release bracket from mount by moving the flag to the open
position. (See Figure 2)
3. Remove bracket from mounting buttons on back of mount.
(See Figure 2)
Figure 2
4. Loosen adjustment knob at the back of the mounting unit
and adjust height of mount to a height greater than the
height of the CPU to be installed. Loosen strap at the front
of the mount if necessary. (See Figure 3)
Figure 3
5. Loosen adjustment knobs on top and bottom of the mount
and slide flanges in order to allow for the CPU to be inserted
for mounting. (See Figure 4)
NOTE: Top and bottom knobs can be removed and inserted
into the front square holes in order to allow for large
CPU’s to be installed. (See Figure 4)
NOTE: Flanges may be reversed in order to allow for narrow
CPU’s to be installed in a secure manner. If this is
done, be sure to also to remove and reinstall strap so
that the buckle is facing out for easy adjustment.
Figure 4
6. Set CPU within mount (D). (See Figure 5)
(E) x 4
(D)
1
1
2
Latch open
Latch closed
3
Strap
3
4
4