CHIEF ER Series - Manual (Page 4)

ER Rack Series Installation Instructions
4
INSTALLATION
1. Lay two side panels (B) flat with pilot holes facing up. (See
Figure 1)
2. Orient one rack rail so that the shorter edge of rack rail faces
the front of the rack. (See Figure 1)
3. Attach rack rail (F or G) to side panel (B) using #10 x 5/8"
Phillips wood screw (D) in larger holes on rack rail.
NOTE: All fasteners may not be used. Use one fastener in
each pilot hole in side panels. Number of pilot holes will
vary by model.
4. Repeat Steps 2 and 3 for the second side panel.
Figure 1
5. Place one top/bottom (A) piece standing up on its edge next
to one of the side panel (B) pieces. (See Figure 2)
6. Install one 7mm x 70mm wood screw (C) into predrilled hole
on side panel. Fasten the screw all the way into the panel
but leave somewhat loose until all screws are installed.
(See Figure 2)
7. Install remaining wood screws into the side panel in same
manner.
Figure 2
8. Attach remaining side panel to assembly using one 7mm x
70mm wood screw (C) into predrilled hole on side panel.
Fasten the screw all the way into the panel but leave
somewhat loose until all screws are installed. (See Figure 3)
9. Install remaining wood screws into the side panel in same
manner.
Figure 3
3 (D) x number of pilot holes
Pilot holes
Pilot holes
(B)
Shorter edge
of rack rail
Larger
holes to
attach
rack rail
(F or G)
(A)
(B)
(C) x 3
6
7
(C) x 3
9
8
(B)
(A)