CHIEF ER Series - Manual (Page 5)

Installation Instructions ER Rack Series
5
10. Install the second top/bottom piece (A) into place, using
three 7mm x 70mm wood screws (C) into predrilled holes on
each side panel. Fasten the screws all the way into the
panel but leave somewhat loose until all screws are
installed.
11. Tighten all screws after all sides, base and top are
positioned and aligned.
12. Insert head caps (E) over the 7mm x 70mm screws (C).
LOADING THE RACK
Load Distribution
CAUTION: BEGIN PLACEMENT OF LOAD AT BOTTOM
OF RACK! Load rack, moving from bottom toward top of rack.
Loading rack incorrectly may result in instability causing
possibly injury and/or damage to components.
1. Begin placement of components into the rack at the lowest
point.
2. Continue placing items into the rack, moving from the
bottom upward.
CAUTION: DISTRIBUTE LOAD CORRECTLY! Load rack
with 2/3 total weight of components in the lower half of rack.
Loading rack incorrectly may result in instability causing
possible injury and/or damage to components.