CHIEF TA410 - Manual (Page 5)

Installation Instructions TA410
5
Installation
1. Remove two hex nuts and mounting buttons from top
interface support of swing arm. (See Figure 1)
Figure 1
2. Attach interface brackets to display according to swing arm
mount installation instructions.
3. Select proper hex nuts to use in Step 4.
• Use 5/16-18 hex nuts (E) if installing to TS525 or
iCF50 (large) mount
• Use 1/4-20 hex nuts (F) if installing to TS3XX or
iCF30 (medium) mount
4. Use four selected nuts (E or F), four washers (D) and four
spacers (C) to attach adapter bracket (A) to interface
brackets. (See Figure 2)
5. Use four #10-24 x 1/2" button head cap screws (G) to
secure adapter bracket (A) to interface brackets. (See
Figure 2)
Figure 2
6. Install two 5/16-18 x 1/2" Phillips pan machine screws (B)
into top two 200 x 200mm holes on adapter bracket (A).
(See Figure 3)
NOTE: Do not fully tighten screws into bracket! Let screws
hang out at least 1/4" in order to allow the screws to
hang onto faceplate in next step!
Figure 3
(medium interface)
1 X 2
(large interface)
top interface support
top interface support
1 X 2
mounting button
mounting button
(E or F) x 4 4
(D) x 4
(C) x 4
(G) x 4 5
(A)
6 (B) x 2
(A)
top of display