Contemporary Research ATSC+SDI - Manual (Page 7)

Contemporary Research 7 ATSC+SDI HDTV Tuner
Front Panel Setup
IR Menu Control – Click Menu button to access on-screen menus.
Setup Menus
Press Setup to enter menus. Use Up and Down buttons to page through options, Left and Right buttons to
change settings. Press Select to enter the setting.
Menu Options
Firmware 232-ATSC+1 V5.0
To update the firmware, click Power and Setup while on this menu while
connected via USB. That will open up a file folder. Copy the file to the tuner
memory, the tuner installs the update itself. Press Left to return to normal
operation.
Also, when this menu is displayed, you can click the Right key to view Bootloader
version, HD version, and DC voltage.
HD Resolution 1080i (Default)
720p
480i
Tune Mode CATV (Default) - Switches tuner to Cable, sets Scan mode (See mode 6)
Off-Air - Switches tuner to Air, sets for Off-Air channel scan
IRC - Switches tuner to Cable, sets Scan mode
HRC - Switches tuner to Cable, sets Scan mode
Cable Auto - Switches tuner to Cable, sets Scan mode
Digital Audio AC-3– Dolby 5.1 (SDI audio will be AC-3)
PCM (SDI audio will be AES stereo, Group 1)
PCM Variable (Default)
Baud Rate 300
600
1200
2400
4800
9600 (default)
19200
Unit Number 1-9, default is 1
Panel Lockout None, Ch+Menu, Vol+Menu, Ch+Vol+Menu, Power, Setup, Menu, All,
Setup+Menu, Pwr+Setup+Menu
Backlight Display brightness 1-10
LCD Contrast Contrast 1-9
IR Receive IR On, IR Off
Captions On, Off (default)
Caption Mode CC1, CC2, CC3, CC4
Text 1, Text1, Text3, Text4 (Text options rarely used)
Digital Captions Service 1-6, Default is 1
Scan Mode Sets how the tuner will scan the channels
Analog+Digital (standard full scan)
Digital – Delete Analog (scan for digital, delete any analog channels)
Digital – Keep Analog (scan for digital, but keep all analog channels)
Analog – Delete Digital (scan for analog, delete any digital channels)
Analog – Keep Digital (scan for analog, but keep all digital channels)
Channel Scan Press Select
Starts the scan, follows the Tune Mode selection
Starts with analog channels, then digital. You can press Select to skip analog.
Overscan Selects % overscan for all channels
0-9