AAON V3-E - Manual (Page 70)

Literature Change History
June 2010
Revision of the IOM adding PVC and CPVC piping Caution.
June 2011
Update of the IOM adding the electronic startup form.
April 2012
Update of the IOM changing the 2” pleated 30% efficient filter from MERV 7 to MERV 8,
adding additional modulating hot gas reheat options to Feature 2, changing the Service
Clearances to allow for coil removal, adding condensate drain connection size information,
changing the required suction riser trap requirement for variable capacity scroll compressor
circuits to every 10 feet, correcting the length of the drip line in piping diagrams to 120”,
correcting the Modulating Hot Gas Reheat and Modulating Hot Gas Reheat with Hot Gas Bypass
piping diagrams to show the liquid line tee connection factory installed, adding the Heat Pump
with Field Installed Modulating Hot Gas Reheat Split System Piping Diagram, adding the index
of tables and figures, and updating the table of contents.
July 2012
Update of the IOM showing that the steam heating coil option is stream distributing (Model
Option B1 = 4)
June 2013
Updated for Rev B design revision change, updated configurator options, updated the filter
information, updated the minimum clearance definitions, added suspension installation
recommendations, and updated the piping diagrams. New part number assigned.
November 2013
Added proper sealing of electrical and gas entries caution.
May 2014
Added electric preheat options and installation information and added TXV sensing bulb
installation instructions.