Datamax-O'Neil MF8I Installation Guide User Manual
Page 9
7
Input Power and Connection Requirements
Datamax-O’Neil MF8i Installation Guide
•
Do not install cables near heat sources.
•
Do not install cables at “pinch locations” (for example, near doors or under a seat).
•
At a minimum, secure cables every 12-18 inches.
•
Allow an adequate 12” loop for connector and disassembly cable.
Existing Power Harness Installation
(part # 220205-100, 220206-100, 220207-100)
The power extension cable is available in lengths of three feet, six feet, and ten feet.
If your vehicle has an existing cable power harness from a previous printer installation, it
may be used to connect to the MF8i printer by using the power extension cable.
Requirements:
•
The existing harness must have a fuse. See Fuse Box Power Cable (part # 220210-
100) on page 6 for the requirements.
•
The cable must be in good condition — no cuts, dings, etc.
Note:
Datamax-O’Neil accepts no liability for improperly installed cabling.
Power Extension Cable