Overview, Contents of the label taken sensor kit, This kit contains the following item – Datamax-O'Neil MP Compact4_MP Compact4 Mobile Mark II Label Taken Sensor Option User Manual
Page 2: 1 x lts compact, 1 x cover lts, 1 x screw (mrx 3x8), 1 x washer (brb 3.2), 1 x screw (rxs z), 1 x cable clamp, Tools required
Advertising
Overview
This document describes the contents, installation, and use of the Label Taken Sensor option for the MP
Compact printers. After verifying the contents of the kit and the tools needed, follow the steps below to
install and begin using the option.
CAUTION
For your safety and to avoid equipment damage, always turn ‘Off’ power and unplug the
printer’s power cord before beginning this installation and when performing service.
Contents of the Label Taken Sensor Kit
This kit contains the following item:
1 x LTS Compact
1 x Cover LTS
1 x Screw (MRX 3x8)
1 x Washer (BRB 3.2)
1 x Screw (RXS Z)
1 x Cable Clamp
Tools Required
To install this option, you will need
Drillbit, 2.5 mm
Phillips
Screwdriver
1
Advertising