Datamax-O'Neil Labelpoint Programmer’s Manual - Manual (Page 50)

PROGRAMMER’S REFERENCE MANUAL
Printer settings
Page 46
44 <n> Alternate end-of-line (EOL) character. This parameter must be set before CR
as end-of-line can be disabled. See parameter 45. Valid values for n are all
decimal ASCII values.
45 6 <n> Disable CR as end-of-line. Only valid when an alternate end-of-line
characters is enabled. See parameter 44. Valid values for n are {0,1} and they
are interpreted as follows:
0 = CR enabled (default)
1 = CR disabled
46
4
<n> Paper strobe time, in µs. The amount of blackness from a given strobe time
depends on paper type used. For most applications, however, the
recommended value is 510µs for Compact models and 350µs for Nova
models.
50 <n> Silent mode. When transferring graphic files this parameter can be used to
disable ACK/NAK responses from the printer. Valid values are {0,1} and they
are interpreted as follows:
0 = printer will respond using ack/nak during file transfers
1 = printer will not respond during file transfers (default).
55
3
Get type of applicator.
0 = None
3 = Blow/Wipe/TampLong
62
3
Printer production year, two digits.
63
3
Printer serial number.
66 <n> Enable application. When Application Center is used, this parameter must be
set for the application to start. Valid values for n are {0, 1} where 0 is disable
and 1 enable. Default is disabled. See the Application Center manual for
more information.
67 <n> Printkey mode. This parameter is used to disable or change the functionality
of the printkey. Normally, a copy of last printout is made. This can be
disabled to make sure that no copy can be made of a unique printout, i.e a
ticket of some kind. It is also possible to trig a new printout, which
corresponds to sending the command ‘!P’. This can also be accomplished
when using a LTS. See parameter 93 for more information. Valid values for n
are {0, 1, 2} and they are interpreted as follows:
0 = copy of last printout (default)
1 = printkey disabled
2 = dormant (or trigged) print
68 <n>
Horizontal print position adjustment, in
1
/
10
mm. Shifts the print picture east
(positive values) or west (negative values). Valid values for n are all integer
values. Default is 0.
6 RAM parameter. Not stored in non-volatile memory.