eLine Technology EDC User Manual - Manual (Page 4)

CAMERA ELI‐EDC USER MANUAL eLineTechnology.com
Page | 4
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
FCC Statement
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
1. THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
2. THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION.
This equipment generates and uses radio frequency energy, and if not installed and used properly, that is, in strict accordance
with the manufacturer’s instructions, it may cause interference to radio and television reception. It has been type tested and
found to comply with the limits for remote control devices in accordance with the specifications in Sub‐Parts B and C of Part 15
of FCC Rules, which are designed to provide reasonable protection against such interference in a residential installation.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
interference to radio or television reception, which can be determined by unplugging the equipment, try to correct the
interference by one or more of the following measures.

Reorient the antenna of the radio/TV experiencing the interference.
 Relocate the equipment with respect to the radio/TV.

Move the equipment away from the radio/TV.
 Plug the equipment into an outlet on a different electrical circuit from the radio/TV experiencing the interference.
If necessary, consult your local dealer for additional suggestions.
NOTE: Modifications to this product will void the user’s authority to operate this equipment.
Product Components
Box Contents
 Dome Camera
 Quick Start User Guide
Additional Materials Needed for Installation
 Minimum of 3 mounting screws and if necessary, drywall anchors
 Tape for protecting connections
 Power supply 12VDC 350mA