eLine Technology EYS-VMS eyStream User Manual Part1 - Manual (Page 80)

80
To create a Speaker system object, you must perform the following steps:
1. In the list of devices, highlight a Server object (1).
2. Click the
button (2).
3. Click the Apply button.
4. When you do this, the Speaker object appears in the list of devices (3).
Creation of the Speaker object is complete.
Configuring a Speaker Object
To configure a Speaker object, you must perform the following steps:
1. In the list of devices, highlight the Speaker object which needs to be configured.
2. Select Yes from the list in the Enable field to activate the Speaker object (1).
3. In the Name field (2), enter the desired name of the Speaker object.
4. In the Audio file field (3), enter the full path to the audio notification file.
5. In the Volume field (4), enter the desired speaker volume level.
Note
When configuring the speaker of an IP device, you can set other
parameters as well, such as the compression algorithm for the audio signal
sent to the speaker for playback. Which speaker parameters you can
configure is determined by the protocol for integration of the IP device and
the EyStream software package
eLineTechnology.com 303.938.8062