eLine Technology PRO3 Effio E - Manual (Page 10)

17 18
NOTE: Make sure you don’t have any missing parts before you make the installation.
Incorrect installation could void the warranty if instructions are not followed correctly.
Please call technical for assistance if you are unsure about any procedures.
Identification
Mechanical Drawing
Installation
Installation information
(General overview)
This bullet camera requires only a few simple steps for installation:
1
With hand you loosen the base, this will allow freedom to drill base into place.
Note: Base does not need to be removed from camera , illustration shown is for clarity of detail.
2 Position camera to suite make sure it is tight. Check you can’t move camera.
Note: Over a long period of time temperature and conditions may effect the grip, this may drift cameras position
3 Attach power and video. Alternative power connector uses middle pin as +
4 If you had not already done so, attach sunvisor with screw, adjust to suite.
Note: Sunshield has a small variation of position, depending on angle the sunsheld may not block out the sun.
5 Check IR LEDs working by just covering the photocel of camera
with your thumb, the IR LEDs will give a faint red glow.
(Don’t look at IR LEDs for long periods of time, as you could damage your eyes)
Accessories
(B) Fitting Screws
PA4 x 35mm 4pcs (A) Wall Plugs
S8 x 30mm 4pcs (C) Sunshield Screw
M3 x5mm
1
2
4 3
190 mm
7 1/2"
61.5 mm
2 1/2"
75 mm
3"
75 mm
3"
Ø 62 mm
2 1/2"
전원 커넥터
비디오 커넥터
Power connector
Type B
Type A
Video connector