Installing the scale – A&D Super Wash Down Scales SW-150KL User Manual
Page 13
11
7.2. Installing the scale
1. Select the place for installing the scale. Refer to “4. PRECAUTIONS”.
2. Adjust the level of the base, using the
spirit level and leveling feet. Confirm
that the bubble is in the center of the
level.
SW type with a display pole has an
extra foot at the bottom of the pole.
Adjust this foot to touch the floor after
adjusting the level of the base.
3. Adjust the display angle as follows.
Type with a display pole
(1)
Rotate the two display knobs
located on the display rear to
remove them.
(2) Tilt the display to an appropriate
angle, 0°, 30°, 60° or 90°.
(3) Attach the two display knobs and
secure them firmly.
Type with a display stand
(1)
Loosen the two display knobs
located on the sides of the display.
(2) Tilt the display to an appropriate
angle. (Free setting angle)
(3) Tighten the two display knobs.
4. Confirm that nothing is touching the switches
and connect the AC power cable to an
electrical outlet.
Leveling foot
Spirit level
The size and shape
depends on the scale model.
Display knobs
Display
Display
Display knobs