Brooks Instrument IPT122 2 Indicating Pressure Transmitters" - Manual (Page 21)

Installation and Operation Manual
X-PR-IPT122-eng
Part Number 541B151AAG
April, 2010
IPT122 Series
4-3
Section 4 Maintenance
4-3 Reassembly
Plugging the six-pin plug in backwards will destroy the sensor.
DO NOT interchange electronic assemblies between the different
gauges (each device is factory matched).
DO NOT adjust the sensor mounting, it is factory set by using
special equipment.
CAUTION !
Insert sensor plug into socket, verifying that the wires on the plug exit as in
the illustration. (See Figure 4-1 Typical Assembly/Disassembly).
1. Install three (3) standoff halves.
2. Install Electronic Assembly to Gauge Assembly.
3. Install three (3) screws on back of gauge.