Brooks Instrument 0254 - Manual (Page 92)

C-14
Model 0254
Section C Serial Communications Protocol Installation and Operation Manual
X-SE-0254-eng
Part Number: 541B129AAG
September, 2010
C-4-3-2 Batch and Blend Control Commands
These commands are provided to conduct output port control operations
that require starting and stopping.
Batch Command
This command is used to start a new batch quantity process, or stop a
batch process that may currently be in processing.
Bulk Batching
Bulk batching starts all qualified batch processes for all qualified channel
ports at the same time.
Qualified channel output ports [Control Function] must be programmed to
[Batch] and [Batch Quantity] set greater than zero, with [Link] to the
channel input port programmed to accumulate quantity.
HOST SEND
AZ F*<cr> start all channel batches
AZ F<cr> stop all channel batches
RESPONSE(S)
AZ,[yyyyy.xx],5,FOK,DA,<cr><lf> batch started and in process
AZ,[yyyyy.xx],5,FDONE,4E,<cr><lf> batch(s) completed
AZ,[yyyyy.xx],5,FERROR,5D,<cr><lf> command error