ADIC FCR 200 - Manual (Page 57)

Ethernet Connection 4-17
Ethernet Connection
10BaseT Ethernet connectivity is used to provide enhanced
management and configuration capabilities. The RJ-45
connector on the unit can be directly connected to a standard
10BaseT Ethernet network.
Configuration is required to set the IP network address to
allow for use of the configuration capabilities of this port.
Refer to Chapter 6 for details on setting the IP network address.
Ethernet capabilities include Telnet for configuration, FTP
and TFTP for firmware upgrades, and SNMP for
configuration and management.
Figure 4-15 FCR200 Ethernet Port
Note
The FCR200
contains a unique
Ethernet MAC
address that is
assigned during
the
manufacturing
process.