ADIC FCR 200 - Manual (Page 71)

SCSI Host to Fibre Channel Target Configuration 5-9
The Index Table is edited to represent the desired mapping,
and saved to FLASH memory.
In addition to configuring the address mapping, SCSI-to-Fibre
Channel mode requires that a SCSI interface on the FCR200 be
configured to respond to specified SCSI IDs. This is done
through the SCSI configuration menu. Target ID’s enabled for
the FCR200 must be unique on the SCSI bus, with the
exception that the initiator ID used on the FCR200 should also
be used as a single target ID. For example, in SCSI-to-Fibre
Channel mode, one of the targets must have the same ID as the
FCR200.
0:4:1 0x10 0
0:4:2 0x17 0
0:4:3 0x18 0
Table 5-2 SCSI-to-Fibre Target:Channel Address
Mapping
SCSI BUS:TARGET:LUN
Fibre Channel
AL_PA LUN
Note
The initiator and
Target ID’s must
be assigned
before the
address table can
be configured.