Camera installation – ELRO C704IP.2 WiFi network pt camera User Manual
Page 22
22
• Double-click on "scan" in the Wireless Lan Settings screen. A list of available wireless
networks will appear.
• Click on your wireless network.
• If you do not require a password for your wireless network, just click on 'submit' after
this.
• If your wireless network does require a password, you will need to enter your password
after "Share Key" or "key1", depending on the encryption.
• Click on 'submit' after this.
The camera restarts automatically when you click 'submit'. This takes approximately 30
seconds.
• Close your browser and camera tool after the computer has restarted.
• Remove the network cable from the camera.
• Open the IP camera tool and click on your camera's address. You can now operate your
camera wirelessly.
• If your camera is not in the camera tool window, right click on the tool window, then
press the "refresh camera list" option.
4.6. Camera installation
!
Please note! Make sure that the camera functions properly in the chosen location
before starting installation.
You can choose to place the camera on a flat surface, or to attach the camera to the
location of your choice with screws.
You can install the camera either with or without the base.
4.6.1. Installing the camera without the base
6
• Screw two of the included screws into the surface where you want to mount the
camera, 68 mm apart.
!
Please note! If the surface is too hard for the screws (stone/concrete), you will need to
drill holes and use the screw plugs which are included.
• Use the two slots on the bottom of the camera to mount the camera on the screws.
4.6.2. Installing the camera with the base
• Unscrew the hinge on the base until loose.
7
• Adjust the angle of the base as desired. Then tighten the hinge again.
• Screw the base of the camera into the surface of your choice, using two of the included
screws.
8
!
Please note! If the surface is too hard for the screws (stone/concrete), you will need to
drill holes and use the screw plugs which are included.
• Then screw the camera onto the base, using the knob underneath the base.
9