Hellwig Air 6091 - Manual (Page 5)

5. Attach axle bracket to air spring as shown. The reinforcement braces are to be
installed over the coil seat on the axle. Note that the bracket is installed so that
the braces are under the air spring. The section of the axle bracket without
braces will be installed so that it faces inboard toward the center of the axle.
There are differences in how the brackets attach to the air spring for the driver
and passenger assemblies. On the passenger side assembly attach the 3/8-16 x
1-3/4” bolt and 1-1/4” spacer to air spring and axle bracket as shown. Then at-
tach 3/8-16 x 1” bolt to air spring through middle hole of axle bracket as shown.
Snug bolts but do not tighten to allow for adjustment. On the driver side assem-
bly attach the axle bracket to the air spring using the slotted holes as shown us-
ing 3/8-16 x1” bolts. Snug bolts but do not tighten to allow for adjustment.
Driver Side
3/8-16 x 1” Bolt
Passenger Side
3/8-16 x 1” Bolt
3/8-16 x 1-3/4”
Bolt Install 1-
1/4” spacer
tube between
bracket and air
spring
Passenger Side
3/8-16 x 1-3/4” Bolt
Install 1-1/4” spacer
tube between
bracket and air
This end inboard This end inboard
Coil spring seat—install
bracket so that reinforcement
braces center bracket on seat.
6091 ( R-6091) 03/09/07