Hellwig Air 6110 - Manual (Page 6)

8. Install air spring assembly between frame and axle as shown. Insert threaded studs
into mating holes in frame bracket. Attach assembly with 3/8” flange nut on outboard
(3/8” x 1” ) stud first. Install frame reinforcement over inboard (3/8” x 1-1/2”) studs
as shown. Make sure frame reinforcement is squarely positioned against inboard wall
of frame rail. Tighten flange nuts to 20-25 ft-lb.
Flanged lock nut
Frame Reinforcement
Flange Nut
Threaded Stud
Saddle Lock Nut
9. Attach air spring assembly to
axle with 3/8” threaded studs
as shown in photo. Insert
threaded studs into threaded
holes in axle bracket. Lock
studs to bracket with flange
nut. Attach saddle to axle us-
ing locknuts. Torque nuts to
20-25 ft-lb. Saddle will flex
as it is tightened to fit secure-
ly against axle.
6110( R-6110)
DO NOT INFLATE AIR SPRINGS OVER 50 PSI
01/24/2013