Hellwig Power Lift 6097 - Manual (Page 7)

8. Passenger side—Place 3/8-16x2-3/4” bolts through slotted holes in axle bracket as shown
and attach qty 2 axle straps to passenger side axle bracket using washers and 3/8” locknuts.
Driver side—Attach 1 axle strap to outboard side of axle bracket only. Place qty (2) 1/4”
thick washers between axle bracket and panhard axle bracket as shown. Shim axle bracket
with additional flat washers until bracket is parallel with axle. Insert 3/8-16 x 1-1/2 bolt and
tighten locknut to 20 ft-lb. Tighten nuts on axle straps until legs of axle straps bend slightly.
Relocate brake lines so that they do not interfere with axle brackets, bolts, straps and air
springs.
Thick washers
Driver side
Driver Side
Passenger Side
6097 ( R-6097) 10/03/2007