Hellwig Power Lift 6097 - Manual (Page 8)

9. Remove factory brake line bracket from axle and install brake relocation bracket using axle
cover bolt and 5/16” bolt and nut to attach brake hoses to bracket. Failure to properly install
bracket will result in contact between the brake lines and leveling valve.
10. Recheck all fasteners for proper torque and ensure adequate clearance to all vehicle com-
ponents – exhaust, brake hoses, brake lines, shocks, differential, etc.
MAKE SURE THAT
PASSENGER SIDE PANHARD BOLT WILL NOT CONTACT AIR SPRING DURING
USE. A minimum of 1/2” clearance is required. If necessary, remove and re-install panhard
bolt with bolt head facing air spring to provide clearance.
Panhard bolt
Dual brake hose.
Relocation Bracket
6097 ( R-6097) 10/03/2007