Hellwig Sway Bar 6806 User Manual
Page 2
TORQUE TABLE
Bolt Size 3/8”— 35 ft lbs * Bolt Size 7/16”— 45 ft lbs* Bolt Size 1/2”—75 ft lbs *Bolt Size 9/16”— 90 ft lbs
SAFETY
: BEFORE BEGINNING INSTALLATION BE SURE TO SET THE PARKING BRAKE AND CHOCK THE
WHEELS.
NOTE:
TO EASE INSTALLATION AND PROPERLY ADJUST THE BAR, THE WEIGHT OF THE VEHICLE
MUST BE ON THE SUSPENSION AS IF DRIVING DOWN THE ROAD. DO NOT RAISE THE VEHICLE BY THE
FRAME.
NOTE: THIS KIT REQUIRES DRILLING THE FRAME RAIL AND POSSIBLE RELOCATION
OF FUEL AND BRAKE LINES. INSTALLER MUST ENSURE THAT THE SWAY BAR KIT
WILL NOT INTERFERE WITH ANY FUEL OR BRAKE LINES OR HOSES.
1.
Lubricate the D shaped bushings and place them onto the straight areas of the bar on each side of the center hump as close to
the outside bend as possible.
2. Disconnect vent hose from breather vent on axle. Remove the breather vent bolt from axle. Place spacer washer under
brake line tee and re attach vent bolt as shown in PHOTO 2. Reconnect vent hose.
3. Hold bar up to the axle and locate the position on the axle tubes to mount the u-bolts. Be sure to put the U-Bolts Under
Any Brake Lines, Wires or Hoses on the Axle to Avoid Any Possible Damage. The threads of the U-Bolts will point
down.
6806 (R-6806)
07/14/04
559-734-7451 800-367-5480 FAX 559-734-7460