Hach-Lange LDO101-30 Instruction Sheet - Manual (Page 2)

2
LDO101-05, LDO101-10, LDO101-15, or LDO101-30 Probe
Removing and Replacing the Shroud
Important Note: Do not remove the cable from the probe. Doing so can damage
the probe.
The LDO101 Probe comes fully assembled. Remove the shroud to change the sensor cap
or calibrate the probe. Refer to the Sensor Cap Instruction Sheet for information on
changing the sensor cap (Cat. No. 5811289).
Removing the Shroud
1. Hold the shroud ( Figure 2 , item 1 ) and unscrew the locking ring ( Figure 2 , item 2 ).
2. Pull the shroud toward the sensor end of the probe. Resistance will be felt until the
locking ribs on the shroud disengage from the locking groove on the probe body.
3. Completely remove the shroud and locking ring and set them aside.
Figure 1 The LDO101-05, LDO101-10, LDO101-15, or LDO101-30 Probe
1 Probe Body with Shroud 4 Pressure-sensor Module
2 Locations for Color Code Clip Installation 5 iButton ®
3 5-, 10-, 15-, or 30-meter Cable 6 Cap