Hach-Lange LUMISTOX 300 Basic User Manual - Manual (Page 15)

English 14
If necessary, connect the LUMIStox 300 with a printer through the 35-pin
parallel (par) interface or with a computer through the 9-pin serial (ser)
interface. Connect all devices to the power supply through the power
cables. Make sure that the LUMIStox 300 system diskette is in the
diskette drive. If this is not the case, insert the appropriate system
diskette.
•
The system diskette must be inserted to operate the device!
• The write-protection must not be activated.
• Before any transporting, the diskette must be removed from the
drive!
Switch on the peripheral devices first through the power switch, then the
LUMIStox 300. With an automatic display sequence like a PC, the
LUMIStox 300 starts up until the display of <Temp: ___._°C please
wait>.
Figure 1 LUMIStox 300 device layout
Quick start
1. Switch on printer or PC.
2. Insert system diskette in the LUMIStox 300.
3. Switch on LUMIStox 300 measurement device.
4. Switch on LUMIStherm incubation block.
N O T I C E
Use only an earthed socket for the connection of this device to the power supply.
If you are not sure if the socket is earthed, have this checked by a qualified
electrician.
The power plug serves in addition to the power supply to isolate the device
quickly from the mains where necessary.
This is recommended for long-term disuse and can prevent potential dangers
in the event of a fault.
Therefore make sure that socket to which the device is connected is easy to reach
by each user at all times.
1 Mains connection 6 25-pin parallel (par) connection
2 Power switch with mains fuse 7 3.5´´ diskette drive
3 Liquid crystal screen 8 Type plate
4 Numeric keyboard 9 Cell compartment
5 9-pin serial (ser) connection F1–F4 function keys
DR LANGE LUMIStox
1 2 3
4 5 6
7 8 9
. 0 C
F1 F2 F3 F4
3
4
2
1
5 6
7
8
9