INSTEON RemoteLinc 2440_2440BK Manual - Manual (Page 9)

RemoteLinc Owner’s Manual
Page 9 of 13
Stuck Button Feature
If any button on RemoteLinc is depressed for longer than 60 seconds, the Controller will enter sleep
mode until the button is released. This feature is provided to preserve the battery life in situations like
RemoteLinc falling between sofa cushions.
Restoring Power to RemoteLinc
RemoteLinc stores all of its settings, such as Links to other INSTEON devices, On-Levels/Ramp Rates,
etc., with non-volatile memory. Because settings are saved in this non-volatile memory, they will not be
lost when the batteries are removed.
Resetting RemoteLinc to its Factory Default Settings
The factory reset procedure will clear RemoteLinc of all INSTEON Links.
1) If you are using RemoteLinc to control any INSTEON devices, Unlink those devices from
RemoteLinc. See Unlinking an INSTEON Responder from RemoteLinc.
2) Remove a single battery from RemoteLinc for at least 10 seconds
3) While holding down the Bright button, reinsert the battery into RemoteLinc (ensure the battery is
properly oriented), making sure not to let up on the Bright button
RemoteLinc should beep and its Status LED should turn on solid
4) Once the battery has been reinserted, continue to hold down the Bright button for about 10 seconds,
and then release
While the Bright button is held down, RemoteLinc should beep continuously
Once the Bright button is released, RemoteLinc should double-beep and its Status LED should
turn off