INSTEON Keypad Dimmer (Dual-Band) (2334-2xx US) Quick Start User Manual
Quick start guide, Insteon
2334-222/2334-232 Rev. 6/19/2013 10:25 AM / See Owner’s Manual for Warranty Information.
Protected under U.S. and foreign patents (se
© Copyright 2013 INSTEON, 16542 Millikan Ave., Irvine, CA 92606,
866-243-8022
Secondary
buttons
Set button
Quick Start Guide
INSTEON
®
Keypad Dimmer Switch, 6 and
8-Button
Models: 2334-222, 2334-232
What’s Included?
•
KeypadLinc Dimmer (6 or 8-button)
•
Four wire nuts
Tools Needed
•
Bladed #1 screwdriver
• Voltage meter
•
Philips screwdriver
• Wire cutter/stripper
Installing Keypad
Installation should only be performed by a qualified electrician or a homeowner who is familiar and comfortable with electrical
circuitry. If you have questions, consult an electrician or call the INSTEON Support Line at 866-243-8022
1)
Turn off breaker/fuse and verify that the power is off
2)
Unscrew existing switch, disconnect wires and prep all wires to be connected to Keypad, with 1/2” (12mm) of bare wire on
the ends
3)
Firmly connect wires per table/diagram and ensure no exposed wire.
4)
Place Keypad into wall box and turn on breaker/fuse
Connected load will turn on
Keypad On button will turn on
5)
Test by tapping Keypad on/off buttons
Connected load will turn on and off
For 6-button, Keypad On button will turn on when on and Off button
will turn on when off
For 8-button, Keypad “Main On/Off” button will turn on and off
Using Keypad
•
Connected load will react just like the scene responders to on/off button taps
•
LED will mimic the on/off status of a dimmer whose scene level is 100% bright
•
Other buttons toggle by default
Button Type
Button LED
before Tap
First Press and Hold
Subsequent Press and Holds
Toggle
Off
Brighten scene until
release
Opposite of last press and hold
(e.g. if last was brighten, it will dim)
Toggle
On
Dim scene until release
Opposite of last press and hold
(e.g. if last was brighten, it will dim)
Always On
Either
Brighten scene until release
Always Off
Either
Dim scene until release
Keypad Wire
Wall Box Wires
Bare Copper
Ground - commonly bare, green wire
or green screw
White
Neutral - commonly white
Red
Load - light, load, etc.
Black
Line - 100 – 277V (commonly black)
Primary
Load
Control