Alliance Laundry Systems UC80PN - Manual (Page 17)

F232073 15
Safety
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
The following table lists the various displays and
what they mean. The operator should become
familiar with these computer displays.
Display Indications
Display Meaning Display Meaning
S-05
Program identification code (ROM)
This is an example only.
bFIL Warm fill (both hot and cold)
Hold Wait...power has just been turned on. HFIL Hot fill
CY Cycle (followed by two-digit number) LOLE Low water level
CHEC/CYC* Test cycle selected. HILE High water level
FAr Degrees Fahrenheit SUP1 Supply 1
CEL Degrees Celsius SUP2 Supply 2
PrE Prewash segment (1st of 8 segments) SUP3 Supply 3
UASH Wash segment (2nd of 8 segments) SUP4 Supply 4
FIL1 First rinse (3rd of 8 segments) SUP5 Supply 5 (supply 1 and 2)
FIL2 Second rinse (4th of 8 segments) SUP6 Supply 6 (supply 2 and 3)
FIL3 Third rinse (5th of 8 segments) SUP7 Supply 7 (supply 3 and 4)
FIL4 Fourth rinse (6th of 8 segments) STOP Stop routine
FIL5 Fifth rinse (7th of 8 segments) SdLY Spin coast delay
FIL6 Sixth rinse (8th of 8 segments) donE Cycle and stop routine have ended.
CFIL Cold fill door Door not properly closed.
SPIn/tIME*
Reads “SPIn” for one second, then
“tIME” followed by time for spin.
FILL/STOP*
Programmed water level not reached after 30
minutes.
tSFL
Temperature sensor failure or temperature
out of range.
FULL
The computer detects low water level or higher
when none should be present.
*Display indications separated by a slash represent an alternating display.