IQinVision Alliance-pro Series - Manual (Page 9)

9
a. Power the camera using either direct power or Power-over-Ethernet.
1. Direct Power: Connect either a 12-24VDC or 24VAC power source to the
camera. Wire polarity is not important, therefore + or – connections can be
connected to either terminal as shown in Figure 9.2.
NOTE: Using a power source with specifications other than those defined will damage the camera, and
will void the product warranty.
2. Power-over-Ethernet: Input from an IEEE802.3af Power-over-Ethernet (PoE)
injector or switch.
b. Route and connect the Ethernet cable to the Ethernet port on the camera as
shown in Figure 9.3.
Figure 9.2
Figure 9.3