IQinVision Alliance-mini Series IQD3x - Manual (Page 5)

6 Mounting on to an Interior Durable Surface Wall
1. Remove the trim cover
Interior Vandal Camera Model: using the supplied Torx T-10 security wrench
loosen the two tamper-proof screws holding the dome cover to the camera
assembly. Note that these screws are not captively held to the dome cover. If
lost, two spare tamper-proof screws are provided. If using a PoE Ethernet cable
coming through the wall, be sure to run this cable through the cable pass-
through in the camera base plate and connect it to the Ethernet port on the
camera as shown in Image 6.1.
Note: The H.264 camera models include an internal microphone. The microphone is disabled by
default.
If an external microphone or powered loudspeaker (not supplied) will be
connected to the mini dome camera use the supplied audio cable. Pass the audio
cable through the camera base plate and connect it to the audio connector on the
camera as shown in Image 6.2. External microphone and powered loudspeaker
(not supplied) will connect to the 3.5 mm plugs.
Image 6.1
5
Side 1 Side 2 Cover Removal Ethernet Pass-Through
Image 6.2