IQinVision Alliance-mini Series IQD3x - Manual (Page 6)

2. Mount the IQeye Alliance-mini camera base to the desired wall or
ceiling surface using the supplied or equivalent mounting hardware.
3. Remove the camera shroud by placing
the palm over the top of the shroud, then
gently squeezing the two tabs toward the
front of the shroud toward the center of
the camera. Pivot these tabs away from
the camera then pull the shroud off the
camera as shown in Image 6.3.
4. Set the field-of-view using the IQeye
Alliance-mini’s 3-axis gimbal.
5. Focus the camera.
Varifocal Lens: Adjust the field-of-view
and focus rings to focus the lens. Be sure
to lock the lens ring thumbscrews when
desired focus is achieved as shown in
Image 6.4.
Fixed Focal Lens: Focus the lens by
twisting the lens clockwise or counter
clockwise to achieve the desired focus.
Then lock the lens in place by tightening
the locking ring as shown in Image 6.5.
6. Replace the camera shroud by first
positioning the shroud against the rear
shroud tab then pivoting the shroud
down toward the front two mounting
tabs. Squeeze the shroud gently and
push it down to engage the front two
mounting tabs.
7. Replace the trim cover.
Position the dome cover so the dome
cover screws line up with the matching
receiving holes on the mounting plate
(Image 6.6). Tighten the dome cover to
the mounting plate using the supplied
Torx T-10 security wrench.
Note: The cover fits in only one orientation. Do not apply excessive
force or damage to the trim cover may occur. If it does not push down
easily on to the camera, the cover may be flipped 180° from the
correct orientation. Remove the cover, flip it 180° and try again. An
easy way to identify the correct orientation is to look for the “Activity
LED” hole in the trim ring and align that on the same side of the
camera as the Activity LED.
Image 6.3
Image 6.5
Image 6.6
6
Image 6.4