IQinVision Alliance & Sentinel Series Pole Mount Adaptor - Manual (Page 3)

3
1. Unpacking
Remove the Pole Mount Adapter and related hardware
from the box
Hardware included in the box should include:
a. (1) IQinVision Pole Mount Adapter for the Alliance or Sentinel 8xx Series
camera.
b. (4) 1-inch M6 Allen head screws for mounting the Alliance (with Outdoor
Back Box and Wall Mount Kit) or Sentinel Junction box (not included) to the
Pole Mount Adapter
c. (1) 5mm Allen wrench
d. (4) Spring lock washers
e. (2) BAND-IT(R) 0.5 inch (12.7mm) x 48-inch (1.22 M) metal tensioning
strap
Tools needed for assembly include:
a. Tensioning tool
b. Hammer
2. Attaching Alliance/Junction Box to
Adapter
a. Attach Alliance (with Outdoor Back Box & Wall Mount
Kit) to Pole Mount Adapter
i. Thread the Ethernet cable and any other secondary cabling through the
center hole in the Pole Mount Adapter and through the 3/4” conduit hole in
the side of the Alliance Outdoor Back Box.
ii. Attach the Alliance Outdoor Back Box to the Alliance Wall Mount using the
supplied or equivalent hardware.
iii. Line up the four mounting holes on the Alliance Wall Mount with the
corresponding holes on the face of the Pole Mount Adapter. Using the 5mm
Allen wrench, secure the 4 included 1-inch M6 Allen head screws through
the mount holes in the Alliance Wall Mount to the threaded receivers on the
Pole Mount Adapter. Thread supplied spring lock washers onto the 1-inch
M6 Allen head screws.