Maintenance, Sparco, Cycler maintenance – King Technology Sparco System User Manual

Page 6

Advertising
background image

SPARCO

Cycler Maintenance

Replacing the Control Dial O-Rings

Replacing Cap O-Ring

•

Hold cap in front of you

upside down with the o-ring
groove facing up. Place one
end of o-ring into cap groove
at the point closest to you.
Hold o-ring down with the
thumb and forefinger of one
hand.

•

Take hold of the far end of

the o-ring with the thumb and
index finger of the other hand.
Roll o-ring slightly back
towards you as you stretch
the o-ring into the remainder
of the cap groove.

•

Lubricate o-ring often with

silicone lubricant that came
with your Sparco Cycler. DO
NOT USE petroleum based
lubricants.

Replacing knob

COPY
COPY

COPY

COPY

xxxxx

SLICONE

LUBRICANT

•

Using a needle nose pliers,

find the snap ring tail located
at approximately the five o'clock
position under the control dial.

•

Pull down and out of the

groove.

•

Using a large screwdriver,

loosen the control dial.
Carefully pry the dial until it
pulls out.

•

Insert the non-lipped end of

snap ring into the groove
opening beginning at the 5
o'clock position and push it up
so that it threads itself around
the control dial.

•

Using a small screwdriver or

pointed tool to help guide it,
make sure the snap ring stays
in the groove as it is inserted.

•

Carefully replace the rubber

o-ring without stretching it.
Apply silicone lubricant, that
came with your Sparco Cycler,
on o-ring.

•

Push control dial completely

into the housing and turn the
dial to setting 2.

COPY
COPY

COPY

COPY

OTHER COPY?

SILICONE

LUBRICANT

•

Replace knob in back or on

cap of Sparco Cycler by
unscrewing old one and
screwing in new one.

6

1.

2.

3.

4.

5.

1.

2.

3.

6.

7.

Advertising