KT&C KPC-HDX210M - Manual (Page 32)

Quick Setup Guide
(HD CCTV CAMERA)
■ OSD Menu Button.
-
Video out Format Change (NTSC/PAL Selection)
Default(Factory default setting) video out format is NTSC.
Camera power on & Until push the SET button(While OSD menu is not displayed on
video), Can select NTSC/PAL video format output on VIDEO port - Push the LEFT
button to select NTSC format video out mode or Push the RIGHT button to select
PAL format video out mode.
*Warning : When HD-SDI out format is setted 1080P, NTSC/PAL video out
is not supported. While OSD menu is not displayed on video, Can select
1080P/720P format output on HD-SDI port - Push the UP button in 3 seconds
to select 720P format video out or Push the DOWN button in 3 seconds to
select 1080p format video out.
- OSD menu Display on Video
Push the SET button.
- Use the Focus mode
Can be found in SYSTEM menu section in OSD menu.
Use the LEFT/RIGHT button to select ON/OFF the Focus mode.
· Video output port
- HDcctv 1.0 OUTPUT (BNC) :
HD-SDI video out to HDcctv DVR or Other HDcctv Signal Equipment.
- VIDEO (BNC) :
NTSC or PAL video out to Hand-Held Test Equipment(TV Monitor).
· Focus Mode
In the Focus mode, the Iris becomes fully open and the TV out screen zooms into
the center in order to make focusing easier.
When turn on the Focus mode, the OSD menu display in turned off automatically
and when turn off the focus mode, the OSD menu display is back.
UP / 720p
DOWN / 1080p
LEFT / NTSC RIGHT / PAL