Cleveland Motion Controls ULTRA SERIES CARTRIDGE TRANSDUCER REV AA - Manual (Page 8)

U LTRA S ERIES S TATIONARY S HAFT T RANSDUCER MAN-70251 R EV . AA
P AGE 8 OF 18
2 S
PECIFICATIONS
Item: Specification:
Transducer Weight
1T 2T 3T
2.9 lbs.
1.32 kg. 4.0 lb.
1.81 kg 5.0 lb.
2.27 kg
Weight + Mounting Kit
1T 2T 3T
Flange 3.9 lbs.
1.77 kg.
5.6 lbs.
2.54 kg 6.6 lbs.
2.99 kg
Bearing 3.3 lbs.
1.50 kg .
4.5 lbs.
2.04 kg
.
5.5 lbs.
2.49 kg.
Pillow Block 5.8 lbs
2.63 kg. 8.2 lbs.
3.72 kg. 9.2 lbs.
4.17 kg.
Material
Strain Sensing beam - heat treated 4140 alloy steel
Body - 1117 Low Carbon steel
Finish Material Corrosion resistant Zinc plated with clear Chromate
Bridge Resistance 135-147 Ohms @ 20 o C
Gage Type Semi-conductor strain gage, gage factor equals 95 (nominal)
Connector Type M12 Quick-disconnect, 4 conductor, DC keyed
Excitation Voltage 5.6 VDC or VAC (RMS) maximum
(Excess voltage can cause permanent damage)
Nominal Output Signal at Rated
MWF +/- 350 mV per Transducer (with 5 VDC or VAC rms excitation
voltage)
Output Impedance Approximately 64 Ohms per Bridge leg
Non-destructive Overload 150% MWF
Ultimate Overload 300% MWF (typ)
Maximum Voltage, Gage to
Beam or Base (Ground) 50 Volts peak
Operating Temperature Range 0 o F to +200 o F
Alignment +/- 1 degrees angular displacement
Accommodation of shaft
expansion/contraction +/- 0.04” (+/ - 1mm) per transducer