Cleveland Motion Controls WebPro Motor Powered Unwind Tension Controller MWP – 12662 - 1 REV BA - Manual (Page 13)

AO-70172
12
Revision BA
WebPro Motor Powered Unwind Tension Controller
Machine Parameters
From the Commissioning Menu; press 1 to show the Machine Parameters screen
Machine Parameters (SET UP = cancel) changed
by
using
default
value
Language English Deutsch Français Italiano Español
Unit system S.I. / Metric kgf / Pound/foot / Percent
Controller application Unwind
Unwind type * Brake / Speed / Torque
Output range 0-10V / 0-20mA / 4-20mA / 0-50mA
Start in control screen No / Yes
Enable MAN/AUTO/OFF keys No / Yes
Dual tension range
No / Yes
Full scale (low) Enter a value
Full scale (normal) Enter a value
Minimum tension 3% minimum, 20% maximum
Static friction Torque mode only, 10% maximum
Dynamic friction Torque mode only, 20% maximum
Output level bias 20% maximum
Output level limit 100% maximum
Set point ramp rate 1% per second, 100% per second
Soft stop time 10 seconds maximum
Display damping time 0.1 seconds, 3 seconds
Display precision 0.1, 0.5, 1, 5, 10
Digital inputs
MACHINE START Disabled, 0V=OFF, 0V=ON
SELECT AUTO Disabled, 0V=OFF, 0V=ON
SELECT MANUAL Disabled, 0V=OFF, 0V=ON
SELECT OFF Disabled, 0V=OFF, 0V=ON
DIAMETER HOLD Disabled, 0V=OFF, 0V=ON
DIAMETER RESET Disabled, 0V=OFF, 0V=ON
BATCH HOLD Disabled, 0V=OFF, 0V=ON
ENABLE EXT SP Disabled, 0V=OFF, 0V=ON
Show internal calibration *
No / Yes
Right transducer Disabled, Enabled
Line tacho or encoder * Disabled, Tacho, Encoder
Winder tacho or encoder * Disabled, Tacho, Encoder
+/-
+/-
+/-
+/-
+/-
+/-
+/-
numeric key
numeric key
numeric key
numeric key
numeric key
numeric key
numeric key
numeric key
numeric key
numeric key
+/-
+/-
+/-
+/-
+/-
+/-
+/-
+/-
+/-
+/-
+/-
+/-
+/- English
S.I.
Brake
0-10V
No
No
No
5000
5000
6%
0%
0%
0%
100%
5%/sec
6 secs
2 secs
1
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
No
Disabled
Disabled
Disabled
An asterisk * indicates that a further menu will open if this item is selected.
Remember to press the CONFIRM key, otherwise the parameters will not be saved to the memory.
Note Start in Control Screen
The Controller is despatched with this item set to "No". We recommend that after all commissioning is
finished that this is then set to "Yes". When the Controller is now switched on, the program is loaded, the
company logos are shown briefly and then the Control or operating screen ready for use by the operator.
Note
The Controller will not accept an invalid input value which is outside the limits of operation. If an invalid
input is attempted the Controller will revert to the previous valid input.