Codelocks KL1500 KitLock Locker Lock - Manual (Page 2)

15
O
O
FITTING INSTRUCTIONS SPECIAL NOTES
Please read carefully:
• Before installing the lock, install the
batteries and familiarise yourself with
the operation and programming.
• The handle will not turn until you enter
the factory default code:
Master Code 11 22 33 44
or the User Code 12 34.
• Please see Programming Guide to set
your new Master and User Codes and to
set different functions on lock if required.
• If required change keypad orientation.
• Select and fit coloured insert with
double sided tape supplied.
LOCKED
The KL1500 is supplied for vertical installation. However, the lock
may be installed in any orientation by simply rotating the keypad module.
Before installation change to desired orientation as follows:
7 Press and hold the 1 button and
replace one battery. The blue LED will
flash twice and the lock will beep twice.
8 Release the 1 button and within three
seconds press the
* button 3 times.
9 The blue LED will flash twice and will
beep twice to confirm numeric module
position reset OK.
10 Replace the handle and fit second
battery.
1 Remove both batteries .
2 Remove lever handle via handle
fixing bolt from rear of lock.
3 Remove four small fixing bolts .
4 Carefully remove the outer lock
shell .
5 Rotate the numeric module (1-9) to
the required position.
6 Replace the outer lock shell and
secure with the 4 small fixing bolts .
The KitLock can be fitted to:
A
Cabinets, cupboards and lockers etc.
as a direct replacement for existing
cam locks.
B It can also be fitted easily to
cupboards and cabinets that do not
have an existing locking device.
OPEN
Fixing bolts x 2
Cam fixing bolt x 1
Cams x 2
Spindles x 4
Door gasket
Battery cover
Batteries x 2
Small fixing bolts x 4
Handle fixing bolt x 1
Lock body
Keypad module
Coloured inserts x 5
Outer lock shell
Handle 1
2
3
4
5
1
1
2
3
4
5 6
7
8
9
10
11
12
13
14
7
8
8
9
11
13
13 14
6 7
8
8
9 10
11
12
13
14
12
kitlock 1500 inst. 8pp_Layout 1 26/06/2013 16:39 Page 5