Auto Page EXP-52 - Manual (Page 11)

EXP-52
9
To code the EXP-52 transmitte rs for two or three vehicles follow the
diagrams as shown below. Before multiple vehicle programming can be
achieved, it is necessary to enter the programming mode as described
in SECTION K.
1. TWO VEHICLE OPERATION
VEHICLE #1
Enter the programming mode on vehicle #1 and push the ON/OFF
button on the transmitter for Vehicle #1. The alarm siren will respond
with a confirming chirp. Within five (5) seconds, push the AUX button on
the transmitter for Vehicle #2. The alarm siren will respond with a
confirming chirp. Both transmitters are now programmed to Vehicle #1.
VEHICLE #2
Enter the programming mode on Vehicle #2 and push the AUX button on
the first transmitter used for Vehicle #1. The alarm siren will respond
with a confirming chirp. Within five (5) seconds, push the ON/OFF button
on the second transmitter that had been previously programmed on
Vehicle #1. The alarm siren will respond with a confirming chirp. Both
transmitters are now programmed to Vehicle #2.
NOTE: Here, the first transmitter is assumed to be the primary
transmitter of Vehicle #1, and the second transmitter is assumed to be
the primary transmitter of Vehicle #2.
VEHICLE #1 VEHICLE #2
TRANSMITTER #1 ON/OFF BUTTON AUX BUTTON
TRANSMITTER #2 AUX BUTTON ON/OFF BUTTON