Auto Page EXP-52 - Manual (Page 8)

EXP-52
6
2. The LED STATUS INDICATOR will begin fast flashing and the
passive arming timer will begin counting down.
3. If you re-open the exit, the LED will stop flashing.
4. Close the exit, and the LED will start flashing again.
5. The EXP-52 will count down for 30 seconds. After 30 seconds,
the siren will chirp 1 time indicating the EXP -52 has armed.
NOTE: If the optional remote power door locks feature is installed, the
doors will automatically lock 10 seconds after the PASSIVE arming cycle
is completed.
2. MANUAL ARMING
If you choose the MANUAL (active) arming mode, follow the steps below.
1. Switch off ignition, leave vehicle, and close all protected openings.
2. Press the ON/OFF button on the remote transmitter.
3. The siren will chirp 1 time. 5 seconds later the EXP -52 will be fully
armed.
G. AUTOMATIC RE-ARMING
The EXP-52 is equipped with an automatic re-arming circuit that will
return the alarm to a fully armed state if a door is not opened within 60
seconds after disarming. This automatic re-arming circuit can be
eliminated at the time of installation.
H.
IGNITION CONTROL POWER DOOR LOCK SYSTEM
When installed with remote power door locks, the vehicle's doors will
automatically lock when the ignition is switched on. The doors will
automatically unlock when the ignition is switched off. In order to avoid
any undesirable lock-out, the doors will not lock if any door is left open.