CTI Products EXB Network Manager - Manual (Page 15)

Hot-Standby EXB / Network Manager Software Manual Software
CTI Products, Inc. Installation
11
68-11707-100
4. Software Installation
This section describes the installation of the MCN EXB Network Management
Software in a PC.
If you are installing the software as an update to a previous version or re-installing
the software, you must remove the previous version first. Please refer to
Appendix A -- Re-Installing the EXB Network Management Program for
instructions.
To install the software:
1. Make sure you have Administrator privileges on the PC.
2. Close all running programs.
3. Insert the CD in the CD drive.
From the Start menu, select Run and type in:
d:\setup.exe
(where d is your CD-ROM drive letter).
4. Follow the instructions in the InstallShield install program.
5. The InstallShield program will install the program in a working directory.
The default working directory is:
c:\Program Files\CTI Products Inc\ExbNetManager.
6. After the files are copied, the PC must be re-started.
7. After you re-start the PC, turn it off again.
8. Install the Gesytec EasyLon Network Interface Card as described in section
3.3 of this manual.
9. Re-start the PC.