Controlled Products Systems Group 222EX43 - Manual (Page 95)

76 © 2010 Installation and Reference Manual D0119 Rev. J
Appendix
— SlideDriver Wheel Change
9. TIGHTEN BOLT TO
APPROXIMATELY 35
– 50*lb.
10. Use a 3/16-inch Allen wrench to
tighten the two bolts securely. Be
sure the collar is seated against the
back of the wheel hub, with the collar
splits between the wheel hub splits.
NOTE: If the collar is not fully seated
against the wheel, it may contact the
motor mounting bolts during
operation.)
11. Re-install the drive wheel assembly in
the operator.