Controlled Products Systems Group RAM3200 - Manual (Page 13)

RAM 3000 • 3100 • 3200
RAMSET
www.ramsetinc.com 11
L.E.D.’s light up when Opening,
Closing or Stopped
“Intelligate” Control Board
puShBuTTON CONTrOLS
Three pushbuttons are located under the dip switches for operation of the gate (see Figure 11). The opening,
stop and closing buttons can be utilized to set limit switches and verify proper system operation when
installing or servicing an operator.
Opening
Pressing this button will cause the gate to open.
Stop
Pressing this button will cause the gate to
stop moving.
Closing
Pressing this button will cause the gate to close.
Reset E.R.D. Board
Push all three pushbuttons for approximately
5 seconds. All three L.E.D.’s should blink.
MASTER / SLAVE INSTALLATION
Set Dip Switch (C8) "Slave Mode" to ON for
slave operator.
(RH) Right Hand operation requires Dip Switch
(C7) "Left/Right" to be ON.
Dip Switch “C”
Figure 12
Figure 11