Laurel Electronics LTE: Ethernet & 4-20 mA Output Transmitter for AC Phase Angle & Power Factor - Manual (Page 2)

LAUREL ELECTRONICS INC. , 3183-G Airway Ave., Costa Mesa, CA 92626, USA • Tel 714-434-6131 • www.laurels.com 2
Specifications
Phase Angle Mode
Item Transmitted
Transmitted Units
Frequency Range
Accuracy
Maximum Timing Interval Phase angle difference between two waves of same period
1°, 0.1°, 0.01°
.005 Hz to 10 kHz
.01°, .005 Hz to 100 Hz, 0.1° at 1 kHz, 1° at 10 kHz
200 s
Power Factor Mode
Item Transmitted
Transmitted Units
Polarity
Frequency Range
Accuracy Power factor between two sine waves of same period
1.000 to 0.000, 1.00 to 0.00, or 1.0 to 1.0
Negative sign indicates negative phase angle
0.005 Hz to 10 kHz
0.1% at power line frequencies
Inputs
Signal Types
Signal Ranges
Signal Ground
Noise Filter Sinusoidal AC and square waves
10 mV to 250 Vac
Common ground for channels A & B
1 MHz, 30 kHz, 250 Hz (selectable)
Update Rate
Conversion Interval
Gate Time
Time Before Zero Output Gate time + 30 ms + 0-2 signal periods
Selectable 10 ms to 199.99 s
Selectable 10 ms to 199.99 s
Analog Output (standard)
Output Levels
Compliance, 4-20 mA
Compliance, 0-10V
Output Resolution
Output Accuracy
Output Isolation 0-20 mA or 0-10 Vdc (selectable)
10V (0-500Ω load)
2 mA (5 kΩ load)
16 bits (65,536 steps)
0.02% of output span plus conversion accuracy
250V rms working, 2.3 kV rms per 1 minute test
Serial Communications (standard)
Type
Data Rates
Output Isolation
Serial Protocols
Modbus Compliance
Digital Addresses 10/100Base-T Ethernet per IEEE 802.3
300, 600, 1200, 2400, 4800, 9600, 19200 baud
250V rms working, 2.3 kV rms per 1 min test
Modbus TCP, Modbus RTU, Modbus ASCII, Laurel ASCII
Modbus over Serial Line Specification V1.0 (2002)
247 for Modbus, 31 for Laurel ASCII
Dual Relay Output (standard)
Relay Type
Load Rating Two solid state relays, SPST, normally open, Form A
120 mA at 140 Vac or 180 Vdc
Sensor Excitation Output (standard)
Output Levels
Output Isolation 5V@100 mA, 10V@120 mA, 24V@50 mA (jumper selectable)
50V from signal ground