Lectrosonics R170 - Manual (Page 5)

RECEIVER REAR PANEL
ANTENNA terminal -- A standard PL 259 connector for mounting the A-185PL antenna, or connecting
the A-185Coax remote antenna.
12V DC INPUT -- Connect the power supply here -- the CH-12 AC adapter is supplied with the receiver
for powering the unit from a 110V AC outlet -- the receiver may also be powered from 12 Volt DC
sources using the correct plug; the center pin is positive(+). (Switchcraft S-760 power plug)
AUDIO OUTPUTS
BAL MIC LEVEL -- 3 pin XLR at microphone level (100mV max.); 200 Ohm impedance for either
balanced or unbalanced inputs
BAL 600 OHM -- 1/4" phone jack at "line" level (700mV max.); 600 Ohm impedance for either balanced
or unbalanced inputs
LINE OUT -- RCA phono jack at "line" level (1 Volt max.); 1K Ohm impedance for unbalanced inputs.
The output level of this RCA jack is not affected by the front panel VOLUME ATTENUATOR control.
AUDIO INPUT (mixing bus)
AUDIO IN -- RCA phono jack input accepts external tape deck or other audio source; mixes audio with
receiver output. Also allows "stacking" multiple receivers (see page 8).
Figure 2 - R170 Rear Panel
4