Lectrosonics UCR201 - Manual (Page 14)

UCR201
REPLACING THE BATTERY
Lift and open the bottom battery door cover with your
thumb, rotate the door clockwise until it is perpendicular
with the case and allow the battery to fall out of the
compartment into your hand. Retaining pins will prevent
you from opening too far. It is difficult to install the
battery backwards. Observe the large and small holes in
the battery contact pad before inserting a new battery.
Insert the contact end of the battery first, making sure
the contacts are aligned with the holes in the contact
pad, and then swing the door closed. You will feel it snap
into place when it is fully closed.
CAUTION
Lithium batteries will expand and swell if allowed to go into a deep
discharge. Be sure to remove lithium batteries as soon as the display
starts flashing. If lithium batteries are allowed to fully discharge
while still inside the battery compartment, they may be very difficult
to remove. Stuck lithium batteries can be avoided by removing the
battery label wrapping before use. This will allow the battery to
swell but will still leave enough room in the compartment for the
battery to fall out normally.
1
2
To open the battery
compartment door, push the
door up and away from the case
with your thumb, then swing
open.
Professional Audio Products Since 1971
14